Craftsman 247.774500 Instrukcja Operatora Pobierz pdf (Strona 9)

• Useaflexible"spider"typecouplingbetween

engineandpumpdriveshafts.

• Keephosesclearandunblocked.

• Bleedairoutofhosesbeforeoperating.

• Flushandcleanhydraulicsystembeforestarting

afteranymalfunctionorservicing.

• Use"pipedope"onallhydraulicfittings.

• Allowtimeforwarm-upbeforesplittingwood.

• Primethepumpbeforeinitialstart-upbyturning

overtheenginewithsparkplugdisconnected.

• Splitwoodwiththegrain(lengthwise)only.

Never:

• Use when fluidis below 20 ° F or above 150° F.

• Use a solid engine/pump coupling.

• Operate through relief valve for more than

several seconds.

• Attempt to adjust unloading or relief valve

settings without pressure gauges.

• Operate with air in hydraulic system.

• Use teflon tape on hydraulic fittings.

• Attempt to cut wood across the grain.

UsingTheLogSplitter

• Place the log splitter on level, dry, and solid

ground.

• Place the beam in either the horizontal or vertical

position and lock in place with the appropriate

locking rod.

• Block the front and back of both wheels.

• Place the log against the end plate and only split

wood in the direction of the grain.

• When necessary to stabilize the log, place your

hand only on sides of log. NEVER place hand on

the end between the log and splitting wedge.

• Only one adult should stabilize the log and

operate the control handle, so the operator has

full control over stabilizing the log and movement

of the splitting wedge.

Control Handle Positions

• Move control handle FORWARD or DOWN to

split wood.

• Release the control handle to stop the wedge

movement.

• Move control handle BACK or UP to return the

wedge.

VerticalPosition

• Pull the horizontal beam lockout to release the

beam and pivot the beam to the vertical position.

• To lock the beam inthe vertical position, pull out

on the vertical beam lockand pivot it to secure

the beam. See Figure 8.

• Stand in front of the log splitterto operate the

control handle and to stabilize the log.

HorizontalPosition

• Pull the vertical beam lock out and pivot it down.

Pivotthe beam to the horizontal position.

• To lock the beam in the horizontal position, pull

out on the horizontal beam lock and pivot it to

secure the beam. See Figure 8.

• Stand behind the reservoir tank to operate the

control handle and to stabilize the log.

Beam Lock

Figure 8

TransportingThe Log Splitter

• Lower the beam to its horizontal position. Make

certain the beam is locked securely with the

horizontal beam lock.

• Remove the spring clip and clevis pin from jack

stand. Support the tongue and pivot the jack

stand up against the tongue. Secure with the

spring clip and clevis pin previously removed.

See Figure 8.

• Attach coupler hitch to a class I or higher 1-7/8"

ball on the towing vehicle, making certain to latch

securely.

• Connect the safety chains to the towing vehicle.

• Do not tow faster than 45mph and check local,

state, and federal requirements before towing on

any public road.

NOTE: Use caution when backing up. It is

recommended to use a spotter outside the vehicle.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 39 40

Komentarze do niniejszej Instrukcji

Brak uwag

Craftsman 247.774500 Instrukcja Operatora Strona 9

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Łuparki drewna Craftsman 247.774500