Craftsman 358.34110 Instrukcja Operatora Pobierz pdf (Strona 16)

.°. _,

Always wear gloves when ha ndlingthe

chain. The chain is sharp enough to cut you even

though it is too dull to cut wood.

1. CHAIN MAINTENANCE

* Sharpen the chain when:

-- Wood chips are small and powdery. Wool

chips 'made by the saw (_hainshould be

about the size of the teeth of the chain.

-- Saw has to be forced through the cut.

-- Saw cuts to one side.

a. CLEAN TREE SAP FROM THE CHAIN

BEFORE IT IS .SHARPENED:

: 1.) .Soak(:hain in a petroleum based solvent

or a detergent and water solution.

2.) Dry chain thoroughly.

3.) Immersethe clean chaininlightoil untiloil

seeps into the rivet holes.

NOTE: Donotrun a chainwhich hasbeen

•cleaned without lubricating it first.

b. SHARPENIN G INSTRU C!"IONS •

ltents required:

Gloves Depth Gauge Tool

5132"roundfile Screwdriver

6" file holder Vise

•:Flatfile

1.) Sharpen Cutters.

a.) Support the square rod on the fife holder

(with5/32" roundfile)onthecuttertopplate

anddepth gauge. Figure 31,

b.) Hold the rite holder levelwiththe 30° guide

mark p_ra!lel to the center of the chain.

Figure 32. .

•c.) File from inside toward outside of cutter,

str_ght across,onforward strokeonly.Use

2 or 3 strokes percutting edge, Figure 32.

d.) Keepallcuttersthe samelength.Figure33.

e.) File enough to remove any damage to

cutting edge (side & top plate) of cutter.

Figure'33: , ..

i.) File 91 G chain to meet specifications.

shown in Figure 34.

_WARNING

Maintain the proper hook angle according to the

manufacturei_'s specification for the Chain you are

Using. Too"muchhook angle will increase the chanc e

of kickback which can result in serious injury. Figums

34 and 36.

2.) Correct Depth Gauges

NOTE: Avoid contact with other parts of the

chain toprevent damage tochain•

a.) Place depth gauge tool (Catalog No.

71-36557) over each cutter depth gauge.

Figure 35.

b.) File level with the flat file if depth gauge is

higherthan the depth gauge tool.

c.) Maintain rounded front corner of depth

gauge with a fiat file, Figure 35 &36.

NOTE: The very top of the depth gauge

should be flat with the front half rounded :

off with a flat file. ' .....

FILE HOLOER

......,

Figure31

CUTTER/_ J

UNE

• , Figure32

CUTTERS REMOVE DAMAGE

IOE PLATE TOP 16t.ATt_

Fig ure33

Figure34 -

Figure 35

HOOK .025.

OUNOED

ORNER

FLIGHT WAY

TOO MUCH SQUARED

HOOK ANGLE

OFF CORNER

WRONG WAY

Figure 36

Jl_ WARNING

Depth gauge tool is required to insure proper depth

gauge filing. Filing the depth gauge too deep will

increase the chance of kickback which can result in

serious injury.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Komentarze do niniejszej Instrukcji

Brak uwag

Craftsman 358.34110 Instrukcja Operatora Strona 16

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Piły łańcuchowe Craftsman 358.34110